First, the early blight: After the onset of leaf mask concentric ring lesions, dark brown, water stains. After the onset of stems, petioles, and fruits, concentric ring vein lesions are also present, and when wet, lesions are black moldy. Control methods: spray 70% mancozeb WP 500 times or 58? Rhododendron wettable powder 800 times, 75? chlorothalonil wettable powder 600 times, 64?矾 WP 500 times, 72.2 普 Propolis 1000 times, once every 7 days, even spray 3 to 4 times. Second, leaf mold: the incidence of the fruit around the pedicle depression black hard spot, irregular yellow lesions on the leaves, produce a brown mold layer when wet, so that leaves yellow, curly, and then fall off. Control methods: 70% mancozeb WP can be used before and after the onset of 500 times fluid, or 50% fasting WP 800 to 1000 times spray, once every 7 days, and even spray 3 to 4 times. Third, the late blight: tomato is a devastating disease, has the characteristics of acute onset, rapid spread and epidemic, - once the disease, if not timely and reasonable prevention and treatment, can be extended to a full shed in a short time lead to pull. The damaged petiole and main stem are dark brown rot and the seedlings are wilting and lodging. The lesion starts from the tip of the tip of the leaf blade. When wet, it has white moldy material. When dry, it is dry and the lesion turns from brown to dark brown, water stain or moire. , slightly sunken, hard fruit. Control methods: 40% Phytonemide WP 300 to 400 times spray can be used for onset, once every 7 days. Fourth, gray mold: seedling damage can cause stems and leaves rot, was stained green to gray-brown, dense surface of gray mold. In the adult stage, the leaves develop from the tip of the leaf to the V-shaped inward extension. The spread of the lesion is not limited by the veins. It develops rapidly when wet, and has a gray-green mold layer. The incidence of stalk stems from the extension of the petiole of the diseased leaf. When the flower is damaged, the petals and stigma are rotted and shed, and the damaged stigma often affects the young fruit. The victim of the fruit begins with the umbilicus or fruit pedicle, and the victim suffers from many diseases. On the surface of the fruit, water-soaked fading spots appear, gradually causing the whole fruit to rot, and the surface of the diseased area is covered with brown-brown moldy layer. Control methods: Before planting, spray the seedlings with 50% Suo Keling WP 1500 times solution or 50% Carbendazim wettable powder 500 times to prevent colonization. When sprayed, add anti-growth agent to the liquid to prevent it. In the early stage of disease, 50% Suo Ke Ling wettable powder 2000 to 300 flowering period can be added in the liquid tincture 0.1% of 50% fasting wettable powder or 50% acetaminophen wettable powder, the effect is very good. V. Viral diseases: There are 6 main types of symptoms in the field, among which mosaic, fern leaf, and stripe are the most common. Mosaic type: There are yellow-green leaves on the leaves or dark and light mottled leaves, veins are transparent, leaves slightly shrunken, and diseased plants are shorter than healthy plants. Fern leaf type: The plants are dwarfed to varying degrees. All or part of the upper leaves become filamentous. The middle and lower leaves are slightly rolled upwards, and the corolla grows longer to form giant flowers. Stripe type: Occurs on leaves, stems, and fruits. Spots vary depending on the site of the lesion. On the leaves are dark brown spots or moire. On the vines dark brown patches, discoloration is only in the surface tissue, not deep inside the stems and fruits. Control methods: 1 spraying at the beginning of the disease, 1.5 times of the disease and disease emulsion 800 times, 2.5 times the virus emulsion 1000 times, every 7 to 10 days, even prevention 3 to 4 times. 2 early control of aphids, whitefly, red spider and so on. 6. Bacterial wilt: Autumn tomato is the most susceptible to bacterial wilt, and usually starts from a large number of flowering results. At the time of initial onset, the leaves and tender stems wilted during the day and returned to normal in the early evening. After many repeated days, the symptoms of wilting increased, and finally the whole plant was bluish and dead, and the diseased stems could flow out of the white fungus liquid. Control methods: use 25% DT wettable powder 600 times spray, can also be used 200 mg / liter of agricultural streptomycin irrigation roots, 0.5 kg per plant, every 7 days, irrigation 3 to 4 times. Seven, spot blotch: mainly damage leaves, but also infect stems and fruits. When the diseased leaves were water-stained, the lesions were nearly round, and the center was grayish white with dark brown edges and slightly sunken, like fish-like, scattered black dots, easily perforated. Control methods: At the beginning of the disease, 70% Mancozeb WP can be used 500 times, or 50% carbendazim WP can be sprayed 500 times.
Losing weight is a behavioral pattern aimed at reducing excess body fat and weight. Moderate weight loss reduces the risk of obesity and improves the health of patients with obesity complications.
Our company specializes in providing raw materials for weight loss, Garcinia Cambogia Extract, White Kidney Bean Extract, Green Tea Extract, etc.
Our company also provides OEM and ODM services
Topiramate Powder,Orlistat Capsule,Metformin Hcl Powder,Weight Loss Raw Materials XI AN RHINE BIOLOGICAL TECHNOLOGY CO.,LTD , https://www.xianrhinebiotech.com
There are two main types of commonly used drugs for the treatment of obesity: one is appetite suppressants that act on the central nervous system: these drugs are also known as anorexia drugs, which reduce serotonin and norepinephrine by affecting the activity of neurotransmitters. Reintake, thereby reducing food intake, suppressing appetite and increasing basal metabolic rate for weight loss, such as sibutamin. There is also a lipase inhibitor that acts on the periphery: by blocking the absorption of part of the fat in the diet to achieve weight loss, patients requiring drug treatment with a BMI greater than 30kg/m2 and no comorbidities, or greater than 28kg/m2 with other comorbidities .
There are also some raw materials, orlistat, liraglutide, cetilistat, etc.
