How to control vegetable water loss

The moisture content of fresh vegetables can reach 65%-96%, but it will gradually lose water and wilt during storage and transportation after harvest, which will reduce the weight of products and cause direct economic loss. In addition, dehydration can also cause product loss. In general, wilting and shrivelling occur when vegetables lose 5% water, and some of them do not reach the level of wilting, but water loss has affected its taste, crispness, color and flavor. Slight wilting can cause imbalance in the metabolism of vegetables and increase the activity of hydrolytic enzymes. For example, dried sweet potatoes are sweetened because dehydration causes the hydrolysis of starch into sugar. When vegetables and vegetables are seriously dehydrated, the concentration of cell fluid increases, and some ions, such as ammonia and hydrogen ions, are too high, causing cell poisoning and even destroying the alternate structure of the protoplasm. Excessive tissue dehydration also causes increased abscisic acid levels and stimulates ethylene synthesis, accelerating organ aging and shedding. In addition, wilting can also cause the decrease of cellular turgor pressure and changes in the mechanical structure characteristics, which will inevitably affect the storage tolerance and disease resistance of vegetables. The greater the degree of tissue dehydration and wilting, the more susceptible it is to infection by microorganisms, and the faster the disease resistance declines. Therefore, in the process of post-harvest processing, storage, and transportation of vegetables, water loss should be controlled as much as possible. However, there are some exceptions, such as onions, garlic, proper drying before storage to accelerate the drying of the scales, promote product dormancy Chinese cabbage should be moderately dry before storage, make the leaves slightly dehydration, can reduce the freezing point, improve the ability of cold resistance. The measures taken to prevent water loss after harvesting vegetables are as follows: 1. The simplest way to pack, wax, or apply film to reduce the loss of water in vegetables is to use plastic film or other waterproof material to cover the product. It can also be packed in bags, boxes or In the paper tray. Polyethylene film is a better waterproof material. However, it must be noted that packaging reduces the water loss of the product while also reducing the cooling rate of the product. In addition, the water absorption capacity of packaging materials can not be ignored. Packaging with compound wax or rosin can prevent the packaging from absorbing water. Although the cost is high, it has practical value in the business. It is also possible to wax or paint the surface of the product and then add appropriate packaging to prevent the product from losing water. Second, increase the air humidity to reduce vegetable water loss is another effective method is to increase the relative humidity of the air, but high humidity is beneficial to the growth of bacteriolysis, can be used in combination with fungicides. Increase the humidity of the air. Use an automatic humidifier to spray fog or steam into the storage area. You can also sprinkle water on the ground or hang wet straw curtains in the storage area, or increase the humidity of the evaporator condensation tubes to keep them below the storage temperature 2-3 One in the range of °C. In short, keeping the relative humidity in the warehouse at about 95% can prevent the product from losing water. Third, appropriate ventilation Whether it is a mechanical or natural ventilation warehouse, adequate ventilation is necessary, it can take away the heat load inside the library, and prevent the temperature inside the library is not uniform, but to minimize the wind speed, 0.3- The wind speed of 3m/s has little effect on product moisture. Fourth, the use of sandwich cold storage folder The cold storage library consists of two walls, in the middle by the cold air circulation, the outer wall is both insulated and moisture-proof, the inner wall is not insulated, the evaporator is placed between the two walls, through Conduction and heat exchange within the warehouse. Since the evaporator is not in the reservoir, it will not capture the moisture in the product and it will be frosted. The humidity inside the reservoir is high, which prevents the product from losing water. Fifth, using the breeze library The breeze of the cold air is sent to the storehouse through the multi-holes on the top of the storehouse or after the cold air is humidified and then sent to the storehouse, which can effectively prevent the loss of water. Preservation of fruits and vegetables is an important aspect of improving quality, and it is necessary to properly treat the product according to the circumstances and effectively maintain its optimal freshness.

Food Ingredients, some natural raw materials can be widely used in food, drink etc. for human's health care.

Powder, oil, pigment etc.


Hot Products

Fish Oil EE/TG

Evening primrose oil

CLA oil

Krill oil

Borage oil

COQ 10

Chitosan


EHP company is a very professional suppiler of health products in China, we want to be your reliable partner in this field.

Food Ingredients

Food Ingredients,Health Ingredients,Fish Oil,Natural Health Ingredients,Seabuckthorn Fruit Oil

Excellent Health Products Co.,Ltd. , http://www.sino-excellent.com