Step description of semi-automatic prefilling machine

The semi-automatic pre-filling machine can pre-prepare a powder square plate with a bottom area of ​​500×500mm2 and a height of about 10mm on four sides. The powder is contained inside, and the powder-filled capsule shell plate is placed flat in the powder square plate. Then, the randomly arranged plexiglass frame is placed on the powder-filled capsule board, and the small shovel shovel powder is put into the frame, and the powder is scraped with the frame edge to fill the powder, and the excess powder is scraped off. Use the capsule cap that is equipped with the capsule cap (draw at the end of the figure, there is a round hole on the set plate), put it on the cap of the capsule cap, and have a matching hole, which is easy to place. Flip the cap of the capsule cap so that the opening of the capsule is facing down, and it is placed on the shell plate of the powdered capsule with the powder installed. There is also a matching hole, which is easy to fit. Put the nested capsule plate into the cavity under the “capsule cap forming plate”, and pull the “pressing bar” down by hand and put it in place, no need to be too strong, because there is a positioning mechanism to control the pressing height. Remove the capsule plate, pour out the capsule, and fill it. You can cycle through the next board.
For the semi-automatic prefiller operation, press the green button in the “Power Switch” and the power is turned on. Slowly adjust the “Vibration Strength Adjustment Knob” and rotate it clockwise. At this time, the finishing disc that is integrated with the “Vibration Bracket” starts to vibrate, and the disc is adjusted by hand to adjust to a certain oscillation intensity. Put the powdered capsule shell into the "filling capsule shell finishing tray", about 300 capsules each time. Put the capsule cap into the "capsule cap finishing tray", about 300 capsules each time. The finishing disc is made of plexiglass plate, and a plurality of round holes with a large upper and lower funnel shape are drilled thereon, and the diameter of the circular hole corresponds to the diameter of the capsule number. At this time, the capsule shell of the vibration table plate is moved slowly before and after, so that it enters the hole of the platen one by one. For about 30 seconds, the powdered capsule shell and capsule cap fall into the round hole with the opening facing up. If the individual opening is facing down, the capsule cap can be pressed down gently to fit out. The horizontal hand-held powder capsule shell plate is gently pushed in the lower part of the sorting tray, and the powder capsule shell in the sorting tray will fall down into the round hole of the board, and then the board is taken out. In the same way, the capsule cap is removed with a capsule cap.
The main performance and characteristics of the semi-automatic pre-filling machine, a wide range of packaging: for a variety of conditions, the nature of the powder. Convenient operation: PLC control, man-machine interface operating system, making operation intuitive and convenient. Easy to adjust: Replace the variety in about ten minutes. Applicable to different types of packaging bags, perfect prevention system, guarantee the yield, and not waste bags and materials. The packaging part of the automatic powder filling machine is made of stainless steel to ensure the hygiene and safety of the materials and meet the GMP standards. High degree of automation: unmanned in the whole process of weighing and packaging, and automatic fault alarm. Part of the imported engineering plastics, no need to refuel, reducing pollution of materials. An oil-free vacuum pump is used to avoid contamination of the production environment. The waterproof design can be washed with water, which reduces the difficulty of cleaning and improves the service life of the semi-automatic pre-filling machine.

Squid Ring

squid Ring

Squid Ring

ZHEJIANG EVERNEW SEAFOOD CO.,LTD , https://www.evernewseafood.com