What should I do if the baler encounters a fault? In general, we will use the baler, but we don't know much about the details of the baler. In many cases, we encountered some thorny problems in the process of using the baler. I don’t know where to start and messed up. So what are the common faults of the baler? What is their solution? Below we Dongtai automatic baler carefully for everyone to analyze: First, the cassette processing, when the belt is stuck in the middle of the roller, or there is a foreign object plugged and can not be taken out, the processing method is as follows: Second, the baler automatic packaging does not automatically take out the belt, in this case, first check whether the "outlet belt length adjustment" is at the "0", and then see if the belt is in the correct process, if not, the belt with the roller near the foreign object, also This will cause this situation. Third, do not cut the belt after tightening, there are many situations that will cause this situation:
a. Disassemble the washer of the hex nut.
b. Loosen the two M5 countersunk screws on the intermediate connecting shaft. Since the two screws are fixed to the notched part of the connecting shaft, the screws must be turned.
c. Remove the connecting shaft, pick up the upper turbine, and remove the jammed objects.
d. Assembly and recovery according to the above cba method.
e. Note that the nut and L-shaped curved plate maintain a gap of 0.3-0.5mm
a. Elastic adjustment is too tight
b. The slippery or slippery belt has oil, which is located near the elastic adjustment, and must be removed to wipe off the oil.
c. The belt is too tight, lower the belt drive down, or adjust the motor to the back.
d. Use a thinner belt or the belt pulley is too large.