Install the double-layer glass reactor . After opening the package, check the packing list to check whether the main parts of the machine are complete. The stainless steel tube and the fixture are assembled in accordance with the drawings as shown in the drawing. Install the electrical box on the top of the right rear pole and tighten the screws and insert the seven-pin plug. Install the vacuum gauge on the left rear end and tighten the screws. According to the height of the double-layer glass reactor, the round bracket of the kettle is fixed on the vertical pole slider, and the kettle is placed on the bracket. The semi-circular hoop is used to fix the neck of the kettle into the pole slider respectively, and is tightened after being closed. Fix the screws, pay attention to the vertical direction of the double-layer glass reactor body when installing. The stir bar is fixed on the ring clamp of the motor main shaft. The stir bar passes through the middle rotary bearing of the cover, tightens the special connector, and then adjusts the position of the motor, paying attention to the vertical concentricity. The slider on the pole is a stainless steel multi-purpose clip that adjusts the direction and height in different directions. It must be cleaned when installing the double-layer glass reactor, and the joints should be coated with Vaseline to prevent the glass from locking up, and then apply vacuum grease to prevent air leakage. Press the universal wheel wheel fixing device to stir. If the stirring is stable, the debugging is good. Double-layer glass reactor before careful inspection of the instrument, whether the glass bottle is damaged, whether the interfaces are consistent, pay attention to light handling. Wipe each interface with a soft cloth (can be replaced with a napkin) and apply a small amount of vacuum grease. (The vacuum grease must be covered after use to prevent the sand from entering.) The interfaces should not be tightened too tightly. It should be loosened regularly to avoid long-term tight locking and cause the connector to bite. Turn on the power switch first, then let the machine run from slow to fast. When the machine is stopped, stop the machine and turn off the switch. The PTFE switches everywhere cannot be tightened too much and easily damage the glass. Each time the double-layer glass reactor is used, it must be cleaned with a soft cloth to remove all traces of oil, stains, and solvent remaining on the surface of the machine. After stopping, loosen the PTFE switches, and the long-term stationary state will deform the PTFE piston. Regularly clean the seal by removing the seal and checking for dirt on the shaft. Wipe it off with a soft cloth, then apply a small amount of vacuum grease and reinstall it to keep the shaft and seal ring smooth. Do not allow water to enter the electrical part. Do not get wet. Original authentic accessories must be purchased, and the use of other accessories can cause fatal damage to the machine. When making any repairs or inspections on the machine, be sure to cut off the power supply and water source. Note that the double-layer glass reactor is a fragile product, please be careful when using it . This article is company information and is prohibited from being reproduced. We are the only hemp manufacturer that integrates planting, processing, sales and transportation, so that we can guarantee 100% traceability of every customer's order. As the world's leading producer and supplier of hemp food ingredients, we have obtained many international food certificates, including HACCP, Organic Certificate, BRC, Kosher, Halal, etc. Quality and food safety have been favored by European and American customers. So far, we have achieved comprehensive cooperation with distributors in Europe and America, and the export volume has ranked first. Industrial hemp,organic hemp protein,organic hemp oil,organic hemp hearts Organicway (xi'an) Food Ingredients Inc. , https://www.organic-powders.com