1. Twist the mushroom. When the hyphae begins to crawl, it should be sprayed with water slightly, and the soil must be sprayed quickly when the soil is crawled. With the increase of the hypha area, the water spray volume should be increased gradually. When the water spray is combined with ventilation, when the mycelium climbs from the surface to 1 ,, the water will reach the maximum limit, and the large ventilation will reduce the temperature, so that the temperature of the material is controlled below 20 °C, so that the hyphae can effectively kink. Control the growth of mycelium to prevent bacterial colonization. In the event of bacterial colonization, increase the ventilation and reduce the temperature, and spray 0.5% lime water. If bacteria are serious and bacteria are formed, the bacteria must be destroyed with a knife or tweezers and combined with the above management methods. When the hypha begins to kink, close the ventilation holes according to the actual conditions in the shed, or ventilate as little as possible. 2. Adjustment of air, temperature and humidity. Mushroom buds generally grow to the size of soybeans, to spray a heavy water. For peat soil, the amount of water spray from the hyphae to the beginning of kinking should reach 7-9 kilograms. Since the mushroom body is small and needs to be sprayed with water, this requires that the water spray should not be too rash and must be completed within three days. At this time, the temperature in the booth should be controlled at 14-16°C, and try not to exceed 20°C. However, in actual operation, due to the constraints of natural conditions, the first tidal mushroom tends to be uneven, especially in the upper and lower layers, at the entrance, at the corner, the mushrooming time is very inconsistent, and the size of the mushroom is not much. In the same way, inconvenience to management, so we must be flexible in practice. The first tidal mushroom is generally sprayed with sufficient amount of water to spray the mushroom water, so that the moisture content of the cover soil is saturated, and then the ventilation hole is closed for 3-5 days. When the mushroom grows to around 1.5-2, the water is sprayed again. Spray, mushrooms less spray. When you spray water, try to avoid high temperatures. You can use water spray sooner or later. When spraying water, be sure to ventilate. Do not close the water. When the water spray is combined with the weather conditions, the outside world is sunny and dry and sprays more, but less rainy days, but do not spray water before harvesting mushrooms to prevent the redness of the mushroom body to reduce the quality of the product. However, water can be sprayed on the day before the mushroom is harvested or harvested. Mushrooms fill the soil before spraying. After 80% of the mushrooms on the bed are finished, spray a heavy water again. Then remove the dead mushrooms and mushroom roots, arrange the bed surface, and close the vents to wait for the emergence of the wet mushroom. 3. In daily management, we must accurately grasp the relationship between ventilation, heat preservation, and moisturizing according to weather changes. (1) In early autumn, the temperature of mushrooming is high, and the growth of mycelium and fruiting bodies is fast. It is necessary to strengthen ventilation and timely adjust moisture so as to maintain the humidity of the mushroom sheds. Ventilation and water drawing are generally selected sooner or later. In the late autumn, the temperature gradually decreases, and the fruiting is also gradually scarce, and the growth is slow. The spray water ventilation should be reduced. Ventilation spray is generally performed at high temperatures at noon. When the temperature in the shed is lower than 8°C, it is necessary to maintain natural mushrooming. Occasionally, when the temperature is high at noon, a small amount of water is sprayed, and when the temperature is short, it is windy. (2) As the temperature drops back day after day, when the temperature is lower than 5 °C it will enter the overwintering management, basically stop the water spray, and keep the cover soil not white. Ventilate at high temperature during the noon and keep the soil dry. Then start to sort out the bed surface, remove dead mushrooms, and remove the old roots and yellowing bacteria. (3) If the amount of mushrooms in the autumn is large and the mycelium is strong, the topsoil of the surface should be gently smashed with scorpions, and then a small amount of lime is sprinkled on the surface, 100 ? 4 生 lime, and thoroughly enter the winter.
What is S-23?
S-23 demonstrates a markedly strong bond to androgen receptors
S-23 is an modern selective androgen receptor modulator (SARM) with the added interest in its potential for male hormonal contraceptive. It binds to the androgen receptor more strongly than older compounds such as Andarine with a Ki of 1.7nM, and in animal studies it showed both a good ratio of anabolic to androgenic effects, and dose-dependent suppression of spermatogenesis with spontaneous recovery after cessation of research.
Added value for research with pronounced suppression of spermatogenesis. Not for human consumption.
S-23 Function
S-23 not only boosted muscle mass, but also reduced fat mass, as studied. SARMs have a bit of a 'soft' image in the doping world. They don't stimulate muscle growth in the way that anabolic Steroids do, but many users say that they are safer.
There are no studies yet that confirm this suspicion. But that S23 is not one of the safer SARMs - we'd be willing to wager a bottle of BCAAs on that.
S23 halts the production of sperm in the testes. In fact it does this so well that the researchers suspect S23 might be a good candidate for a male contraceptive. If this is the case it would probably have to be part of a cocktail that also contains an estradiol analogue, the researchers discovered. The lab animals lost their libido when they were given S23 on its own, and only recovered this when they were given estradiol benzoate together with the S23.
Our company offers variety of products which can meet your multifarious demands.including API Powder.Pharmaceutical Intermediates.Vitamins Powder.Plant Extracts.Food Additive.Peptide Powder and so on We adhere to the management principles of "quality first, customer first and credit-based" since the establishment of the company and always do our best to satisfy potential needs of our customers. Our company is sincerely willing to cooperate with enterprises from all over the world in order to realize a win-win situation since the trend of economic globalization has developed with anirresistible force.
Our company offers variety of products which can meet your multifarious demands.including API Powder.Pharmaceutical Intermediates.Vitamins Powder.Plant Extracts.Food Additive.Peptide Powder and so on We adhere to the management principles of "quality first, customer first and credit-based" since the establishment of the company and always do our best to satisfy potential needs of our customers. Our company is sincerely willing to cooperate with enterprises from all over the world in order to realize a win-win situation since the trend of economic globalization has developed with anirresistible force.
product Photo:
Sarms Liquid,Sarm Pills,Sr9009 Raw Material Powder,Bodybuilding Powder Shaanxi YXchuang Biotechnology Co., Ltd , https://www.peptide-nootropic.com
